The Knee

The knee, like the elbow to some extent, is a hinge joint but not a simple one. The lower part of the thigh bone expands into the femoral condyles and the upper shin bone likewise expands into the tibial condyles, the junction of these two enlarged areas forming the knee joint. The small bone on the outside of the knee, known as the fibula, is not involved in weight bearing nor is actually part of the knee joint, serving only as an attachment area for the muscles controlling the ankle, foot and toes. The knee functions as a hinge dividing the leg, allowing the exertion of high levels of muscular propulsive force, the folding of the leg in bending and the shortening of the leg in stepping to allow efficient gait.

The knee, like the elbow to some extent, is a hinge joint but not a simple one. The lower part of the thigh bone expands into the femoral condyles and the upper shin bone likewise expands into the tibial condyles, the junction of these two enlarged areas forming the knee joint. The small bone on the outside of the knee, known as the fibula, is not involved in weight bearing nor is actually part of the knee joint, serving only as an attachment area for the muscles controlling the ankle, foot and toes. The knee functions as a hinge dividing the leg, allowing the exertion of high levels of muscular propulsive force, the folding of the leg in bending and the shortening of the leg in stepping to allow efficient gait.The quadriceps muscles, the main thigh group, act to bring the knee into its locking position as the joint get closer towards full straightening or extension. The apes and monkeys are not capable of extending their knees in standing so this posture takes high levels of energy, while full extension plus locking of the knee joint allows standing without much effort. The knee joint is rotated inwards by the main quadriceps muscle as it gets close to fully straight and begins to lock. Human upright posture has evolved by this process to permit prolonged standing with very low energy expenditure due to the inactivity in the knee and hip muscles.Inside the joint are two crescent-shaped structures made of cartilage, looking a little like banked tracks, accommodating the large rounded femoral condyles. Their exact function is not clear but they may contribute to guiding the knee towards locking, stabilise the knee by centring the condyles during bending and straightening and evening out any potential unwanted small movements during joint motion. The kneecap is the other part of the knee joint and is a small bone with an inner lining of articular cartilage which is suspended in front of the knee joint.The patella or kneecap is situated in the tendon of the quadriceps muscle which is the major muscle at the front of thigh and responsible for pushing us up from sitting and up and down stairs. The joint surface of the patella fits into the large groove between the front of the femoral condyles, sliding up and down the groove as the knee bends and straightens. The function of the patella appears to be to magnify the power of the quadriceps muscle and so improve its ability to exert the very large forces needed to move the body weight.The flexion and extension plane is the natural plane of knee movement as this normal alignment makes knee pain problems occur less commonly. A bow-legged or knock-kneed posture allows abnormal sideways stresses to be applied to the knee, forcing pressure onto one side of the joint and increasing wear stresses which with time can cause pain symptoms or arthritic changes. Patellar misalignment can also occur, forcing one of its facets against the side of the femoral condyle groove and causing impingement pain due to increase in the friction forces.The high mechanical forces transmitted through the knee are responsible for a variety of knee conditions, often affecting the kneecap or the knee cartilages (more properly called menisci). The knee typically has a range of motion from full extension (stated as zero) to full flexion at around one hundred and forty degrees, depending to some extent on body size and bodily mobility. There is an important degree of internal glide and slide of the femoral condyles as they move on the reciprocally moving tibial surfaces.The gliding of the tibia backwards and forwards makes certain that the femoral condyles will not slide off the tibia during movement. During knee motion one of the bones moves in relation to the other one, in the sense that the movement of one is occurring over the other which is also moving in a complementary pattern. This allows a much greater range of movement than would otherwise be possible. There is a degree of rotation of the femur which occurs at the knee joint and this is obvious as the knee approaches full extension and the femur turns in slightly to achieve the knee lock.Jonathan Blood Smyth, editor of the Physiotherapy Site, writes articles about Physiotherapists, physiotherapy, physiotherapists in Solihull, back pain, orthopaedic conditions, neck pain and injury management. Jonathan is a superintendant physiotherapist at an NHS hospital in the South-West of the UK.




Related Articles

Knee_PainCauses of Chronic Knee Pain. Prevention and Treatment of knee pain....
Back painIf your severe knee pain is unwanted, then this article was written for you....
alternative medicineTotal knee replacement is elective surgery. It is life-enhancing surgery, not life-saving surgery. You may simply decide not to have surgery and live ...
Back painPainful knee joints can be attributed to many knee conditions. Osteoarthritis is one of these conditions. If you want an overview of osteoarthritis an...
As we grow older we begin to experience body pains, especially knee joint pain. This can be just from the wearing on the joints that happens over time...